CALL TOLL-FREE
1-800-DR-OWNER
9
5.
Attach the Upper Right and Left Handlebars to the Middle Handlebar using the remaining two (2) T-Handle Nuts, two (2)
Handle Clamp Bolts, and two (2) Curved Washers (
Figure 2
on page 8). DO NOT over tighten the T-Handle Nuts.
6.
The Drag Stake shipped with its pointed end facing upwards. Remove the Lock Pin, turn the Drag Stake around and direct
the point in the downward position facing towards the Tines, and then reinsert the Lock Pin (
Figure 3
).
8.
Do not discard your packaging material until you are fully satisfied with your new DR PILOT 2 Cycle Tiller/Cultivator.
Figure 3
Drag Stake Tip
pointed forward.
Lock Pin
Summary of Contents for PILOT 2
Page 21: ...CONTACT US AT www DRpower com 21 Schematic Diagram Handlebar Assembly...
Page 23: ...CONTACT US AT www DRpower com 23 Schematic Diagram Transmission Assembly...
Page 25: ...CONTACT US AT www DRpower com 25 Schematic Diagram Engine Assembly...