34
Cause:
Media/Lamination sensors might be not plugged in correctly or turned off.
Fix:
Check if sensors are powered up and plugged correctly into the black sensor box.
Then Retry. If you do not want to keep activated the sensors, click Ignore.
Can’t load sensors
Cause:
The plotter might be switched off or not properly connected.
Fix:
Make sure the plotter is turned on and properly connected.
In case it is turned off, please turn the plotter on and than press the button 2 on
control panel and wait until the display will show “READY” as status. Then press
retry on the popup window.
Error: plotter not found
Cause:
You will get this error when you try to open the last job when you run Cutting
Manager for the first time after the installation.
Fix:
Choose your file through “Open PDF”.
Last job not found
