GRAPHTECH MAINTENANCE
The plotter cuts using a cutter blade mounted in a plunger. There are two different plungers
to suit the diameter of the cutter blade to be mounted (the 0.9 mm cutter plunger is provided
as a standard accessory). Be sure to mount the cutter blade in the corresponding cutter
plunger.
Cutter Plunger
Cutter blade
Plunger
Blade-length adjustment
knob
Plunger-cap
Blade-length
adjustment knob
Plunger
0.9 mm diameter
cutter blade
Plunger-cap (blue)
Hole
Adjust the blade length by turning the blade-length adjustment knob. Turn the knob in
direction “A” to extend the blade, or in direction “B” to retract the blade. When the knob is
turned by one scale unit, the blade moves approximately 0.1 mm. One full turn of the knob
moves the blade approximately 0.5 mm.
WARNING:
It may result in damaging the cutter blade or the
cutting mat if the blade is extended too much. Make sure the
blade length is set less than the thickness of the media.
CAUTION:
To avoid bodily injury, handle cutter blades with care.
Cutter blade moves
approximately 0.1 mm
turning one scale unit
Scale
Scale
25
