33
Cause:
When both the yellow and green LEDs on lamination control panel are on, it
would indicate that either the media or lamination sensor have picked up and error or the
sensors may be out of sync and needs to be calibrated.
Fix:
To fix this, please refer to the
“Yellow and Green LED’s simultaneously on lamination
control board”
guide above to resolve.
The Media or Lamination roll might be finished, please check it. Proceed with
cutting?
Problem:
Yellow and Green light
simultaneously on lamination control
board.
Cause:
You launched the Cutting Manager while the plotter’s lever was down.
Fix:
Rise the lever on the plotter, than press the button 2 on control panel and wait until
the display will show “READY” as status. Then press retry on the popup window.
Error: load the media
Cause:
the software has been opened while the dongle (the red key) was not plugged to
the internal hub or the usb from the virgo was not plugged to the pc.
Fix:
Plug the dongle to the hub, or the virgo usb to the pc and click retry.
Dongle not found
