1. Load empty cardboard core(s) and tighten the core holder, then place the motorized
core holder in position.
2. Peel back the matrix.
3. Pull the matrix and attach it to the matrix remover core holder.
1. Load empty cardboard core(s) and tighten the core holder, then place the motorized
core holder in position.
(Cardboard core(s) width should equal (or narrower) the width of the finished roll).
2. Pull the media through the aluminium rollers and attach the labels to the core using a
waste label.
WARNING:
Before starting a job, always remove the waste
media from the matrix remover core.
Tape the matrix securely onto the cardboard core.
System operating issues may occur if the above
suggestions are not followed.
HOW TO LOAD THE MATRIX REMOVER CORE HOLDER
HOW TO LOAD THE REWINDER CORE HOLDER AND SET THE
SLITTER MODULE
13
