Dover Triton 96 Series, User Manual

Page: 34 / 62

TRITON SYSTEMS, INC.
SECTION 4 - INSTALLATION/REMOVAL
4-12
FULL MOTION VIDEO - USER GUIDE
3b-2 In the ATM upper enclosure, place two cable
clips on the inner back housing surface and
route the 4-Pin Modular Cable through these
clips and into the security vault access hole, as
shown in Figures 4-41 and 4-42.
3b-3 Open the ATM cabinet and feed the modular
cable down through the existing cable clips and
out through the access hole near the bottom of
the cabinet. DO NOT connect the modular cable
to the telephone line at this time!
Step 3, Option B: Install FMV 4-Pin
Modular Cable Using a Dedicated
Telephone Line.
This is an alternative method of installing the FMV
Modular Cable! Use only if the Line Sharing Option
(Step 3, Option A) is NOT used. In this procedure,
the FMV modular cable will be connected through a
surge suppressor module to a facility telephone jack.
3b-1 From inside the Hightopper housing, route the
4-Pin Modular Cable down into the ATM, as
shown in Figure 4-40.
Figure 4-40. Route 4-Pin Modular Cable
into ATM Upper Enclosure.
IMPORTANT!
ENSURE THE SELECTED TELEPHONE LINE IS
NO NO
NO NO
NOT T
T T
T
SHARED WITH THE ATM (PARTY LINE,
LINE-SPLITTER, ETC.) OR ANY OTHER DEVICE.
THE FMV REQUIRES A DEDICATED PHONE
LINE TO PREVENT CONFLICTS WITH ATM
OPERATIONS (CUSTOMER TRANSACTIONS,
DAY CLOSES, ALARM REPORTING, ETC.).
Figure 4-41. Secure 4-Pin Modular
Cable in ATM back housing cable clip.
Figure 4-42. Route 4-Pin Modular Cable
through cable access hole.