RS4203 Manual
Chapter 10 - Clipper and Looper Operation and Adjustments
Rev 32, 01/11/13
Copyright © 2013, Tipper Tie, Inc., All rights reserved
71
Adjusting Loop Idler Arm Tensioning Spring
To adjust the tension on the Loop Idler Arm spring loosen bolt
U
as shown on Detail “B”. Raise the spring
block to increase the tension on the loop idler arm. Lower the spring block to reduce the tension. Tighten
bolt
U
when complete.
Adjusting Loop Strip Plates and Loop Brake
Before a looper is shipped, the Loop Strip Plates are adjusted using the following procedures. After the
Loop Strip Plates are adjusted, they should not have to be adjusted in the field unless a clevis on any of
the cylinders comes loose or if a cylinder needs to be replaced.
Detail “C”
Looper Adjustments
