Dot Hill Systems SANnet II 200, Installation, Operation And Service Manual

Page: 60 / 186

4-28 SANnet II 200 SCSI Array Installation, Operation, and Service Manual • June 2005
6. Press Esc to continue.
A confirmation prompt is displayed.
7. Click Yes to continue.
Note –
You must reset the controller for the configuration to take effect.
You are prompted to reset the controller.
8. Click Yes to reset the controller.
The controller takes a few minutes to format a small storage sector on each physical
drive before logical drives can be successfully initialized.
4.12 Setting Up Out-of-Band Management Over
Ethernet
The controller Ethernet port offers interactive out-of-band management through several
interfaces:
■
The SANscape application. Refer to the SANscape User’s Guide for details.
■
The SANscape Command-Line Interface (CLI). Refer to the SANscape CLI User’s
Guide for details.
■
The firmware application you access when you use the
telnet
command to
connect to the IP address of the controller.
Using an Ethernet connection, you can configure and monitor RAID arrays and
expansion units remotely by using the
telnet
command to access the firmware
application on the array and by using the SANscape or SANscape CLI software.
Note –
If you assign an IP address to an array to manage it out-of-band, for security
reasons consider using an IP address on a private network rather than a publicly
routable network. Using the controller firmware to set a password for the controller
limits unauthorized access to the array. Changing the firmware’s Network Protocol
Support settings can provide further security by disabling the ability to remotely
connect to the array using individual protocols such as HTTP, HTTPS, telnet, FTP, and
SSH. Refer to the “Communication Parameters” section of the
SANnet II Family RAID
Firmware User’s Guide for more information.
Change/Set IP Address ?