Dot Hill Systems SANnet II 200, Installation, Operation And Service Manual

Page: 35 / 186

Chapter 4 Connecting Your SCSI Array 4-3
Figure 4-2 Sequence of Steps to Change Front Bezel Locks So Keys Cannot Be Removed
3. Hold the key in place and use a 12-mm or 3/8-inch nut driver to remove the locking
nut that holds the pawl in place, as shown in the first panel of Figure 4-2.
Caution –
Be sure to hold the key in place. Otherwise there is a risk of breaking the
small tab on the lock that serves as a stop.
4. Lift the pawl off the threaded part of the lock body, as shown in the second panel of
Figure 4-2.
5. Set the pawl aside, face up, so that you can remember its orientation when you replace
it.
6. Use the key to turn the lock 180 degrees, as shown in the third panel of Figure 4-2.
7. Replace the pawl in the same orientation as before, as shown in the fourth panel of
Figure 4-2.