Dot Hill Systems SANnet II 200, Installation, Operation And Service Manual

Page: 123 / 186

Appendix B Cabling JBODs B-13
■ exit
■ help
■ quit
■ select
■ set led
■ show access-mode
■ show configuration
■ show enclosure-status
■ show frus
■ show inquiry-data
■ show led-status
■ show safte-devices
■ version
Refer to the SANscape CLI User’s Guide for information about using these commands.
B.11 Downloading Firmware to Disk Drives in a
JBOD
For instructions on how to download firmware to disk drives in a JBOD directly
attached to a host, refer to the README file in the patch that contains the firmware.
B.12 Managing Disks in the SANnet II 200 JBOD
Array
Use your standard host system disk management utilities for all disk management in a
JBOD array, such as partitioning and formatting. Refer to your host system
documentation for more information about disk management.
For maintenance and troubleshooting information, see “Troubleshooting SANnet II
200 SCSI JBOD Arrays” on page B-13.
B.13 Troubleshooting SANnet II 200 SCSI JBOD
Arrays
This section describes troubleshooting procedures and error messages you can use to
isolate configuration and hardware problems. For additional troubleshooting
information, see Chapter 7.
B.13.1 Troubleshooting Configuration Issues
Follow this sequence of general steps to isolate software and configuration issues.