You can vary the size of the
spray pattern by adjusting the
distance between the atomizer
and the work piece.
Fig. 4: Setting the spray pattern
1. Use valves in the control cabinet or on
the material flow control (1) to adjust the
material flow.
Open the material flow control
on the atomizer when control-
ling via the control cabinet.
2. Use valves in control cabinet to adjust the
atomizer air.
6
Operation
6.1
Safety recommendations
WARNING!
Danger of explosion due to chemical
reactions
Material, halogenated hydrocarbon-based
rinsing agent or cleaning agent can
chemically react with aluminum compo-
nents of the product. Chemical reactions
can cause explosions. Serious injuries
and death can be the consequence.
– Only use rinsing agents and
cleaning agents that do not contain
any halogenated hydrocarbons.
NOTICE!
Material damage due to dried material
residues
If material residues dry in the product,
that can harm components.
– Rinse product immediately after
each use.
6.2
Rinsing
6.2.1 Safety recommendations
NOTICE!
Material damage due to unsuitable
rinsing agent
If the rinsing agent reacts chemically with
the components or the material, compo-
nents get damaged.
– Use only the rinsing agents that are
compatible with the components and
the material.
– Refer to safety data sheet of mate-
rial manufacturer.
6.2.2 General notes
When rinsing, use fluid to remove inner
soiling from components.
Operation
11/2016
EcoGun AS AUTO Mini RS - MSG00007EN
9/28
