Disassembling
1. Thread off control knob (1).
2. Thread off bolt (2).
3. Remove needle spring (3) and plunger
spring (4).
4. Pull out distance bolt (5) and needle (7)
and locknut (6).
5. Loosen lock nut (6).
Adjust
Fig. 9: Setting the distance from the distance
bolt to the piston
6. Hold the needle (7) firmly on the shank.
Turn distance bolts (5).
Turn it to the right to reduce the delay
time.
Turn it to the left to increase the delay
time.
The recommended distance
from the distance bolt (5) to
the piston (9) is 0.3 to 0.5
mm.
7. Tighten the lock nut (6).
Assembling
8.
NOTICE!
Risk of damage to the needle
Lightly pull back the slip ring (8) against
the spring force. Carefully push in dis-
tance bolt (5) with needle (7) and locknut
(6) into the housing.
9. Insert needle spring (3) and plunger
spring (4).
10. Thread in bolt (2).
11. Thread in the control knob (1).
9
Disassembly and Disposal
9.1
Safety recommendations
WARNING!
Risk of injury due to escaping material
and compressed air
Material can escape with high pressure
and penetrate the body. The injury can
look like a harmless cut wound. Death or
serious injuries may result.
– If there are injuries, seek medical
attention immediately.
Before working on the product:
– Disconnect the system with the
product from compressed air and
material supply.
– Secure the system against recon-
nection.
– Relieve the lines.
Disassembly and Disposal
11/2016
EcoGun AS AUTO Mini RS - MSG00007EN
18/28
