Exit Device Operators 630/750/79E/RT/E7900 Series/ Generation E-730 PK3677_T
10-18
19
31. Re-insert the cylinder plug (Fig. 19)
32. While holding the cylinder and plug in
place, insert the key
33. Turn the key approximately 100º clockwise
34. Repeat the steps 1 to 9 to attach the lever
handle to the lock housing. (see Fig. 20)
Fig. 19
Fig. 20
Right-handed lock
Left-handed lock
Preparing the lever handle for Best Removable
Core
F-5 Insert 6-pin Best adapter (thicker)
into 6-pin interchangeable core or
insert 7-pin Best adapter (thinner) into
7-pin interchangeable core. Insert the
adapter until it makes contact with
the removable core.
F-6 Using the control key, assemble the
removable core with its adapter into
the lever. Remove control key.
F-7 Insert the change key into the remov-
able core.
Follow the rest of instructions from step 3.5
of page 12
7 Pins
Thinner
Adapter
6 Pins
Thicker
Adapter
10 How to Change Lock Cylinders
(continued)
CAUTION
WARNING
IMPORTANT
The Key Override itself does not retract the
latch or deadbolt. Do not use too much force
when turning the key as this may damage the
unit. To retract the latch, turn the key clockwise
until it stops, release the key and turn the lever
handle (H). See page 14
The lever handle must stay in the horizontal
position when turning the key (do not try to turn
the key while turning the handle) or the override
mechanism will not work.
Always keep the door open while install-
ing and verifying the functionality of the
E-730/630/750/79E/RT Series lock with the key-
card or key override. Do not close the door until
you are certain that you have installed the unit
correctly.
