Doosan G06030001, Operation & Maintenance Manual

Page: 31 / 90

31 G60, G80, G100, G150, G200-SIIIA OM Manual
OPTIONS [CONT’D]
This screen displays the load parameters of the
generator set in terms of active power, power factor,
reactive power, and apparent power. These values are
indicated in total and per phase.
Figure 13
This screen displays operational information of the
generator set in terms of run hours, number of starts,
number of e-stops, and shutdowns, kW hours, kVAr
hours. Also shown is a definable parameter for service
intervals.
Figure 14
This screen is ONLY shown on engines utilising J1939
Communications. The SPN and FMI diagnostic codes
are shown here as sent from the engine ECU. These
Faults are non latching and are not present when the
Fault is not present. A full listing of Fault Codes is shown
at the end of this manual.
Figure 15
This screen displays the alarm / shutdown list of the
generator set. Inactive faults can be cleared by pressing
the "Fault Reset" button. Up to eight faults can be
displayed on this screen and are "first-in-first out".
CHECKING SOFTWARE VERSION / LAMP TEST
To check the software version and to test the operation of
the LEDs on the control panel, simultaneously press
and .
ADJUSTING THE CONTRAST ON THE DISPLAY
SCREEN
To adjust the contrast on the display screen,
simultaneously press “ENTER” and “INCREASE” or
“DECREASE” to increase or decrease the contrast.
PARAMETER ADJUSTMENTS VIA KEYPAD
Press the “PAGE” button until you reach the parameter
adjustment menu.
Use the “INCREASE” and / or “DECREASE” buttons to
scroll through the parameter menus.
Figure 16
Run Hours 0 h
NumStarts 0
E-Stop 0
Shutdown 0
KW hours 0
KVAr hours 0
Next Srv Time 250 h
ECU Alarm List
>
FC 0 OC 0 FMI 0
Alarm List 2
Not in Auto
Wrn Coolant Level
Password
Basic settings
Engine params
Engine protect
Gener protect
Date/Time
Sensors spec
I/O Module
Parameters Adjust Menu
>