Doosan DX700LC, Operation And Maintenance Manual

Page: 135 / 314

OP001121
2-63
Operating Controls
FRONT WINDOWS
Front Upper Window
The front upper window can be housed in the cabin's ceiling.
Opening the Window
1. Lower bucket to ground.
2. Set safety lever (Figure 147) on "LOCK".
3. Set engine speed control dial to "LOW IDLE". Allow engine
to idle for three - five minutes.
4. Shut down engine by turning key to "O" (OFF) position.
5. Hold the window handles (1, Figure 148), then pull the lock
levers (2) to release the lock. The top of the front window
will come out.
6. Pull window up, and push it against lock pin at the rear of
the cabin. Make sure that it is securely latched.
7. Check that lock levers are securely latched in the lock
position.
NOTE: When the front upper window is open, never
extend your head or body through the window
frame.
NOTE: If the window happens to fall with a strong
impact against the machine, while some part of
your body is extended out of the cabin, it may
result in bodily injury.
Figure 147
FG000189
WARNING
When leaving operator's seat, set the safety lever to
"LOCK" position (Figure 147), if not a serious accident
could occur by accidentally moving the work levers.
Figure 148
1
2
FG000192
WARNING
When stowing front window in the cabin roof, make sure
both release levers (1, Figure 148) are latched.