To DELETE all of the processes on a USB memory stick, select the
“Delete All” button under “Memory Stick” list and then select “Yes”
when prompted.
Machine Operation
Polishing Fixture Installation
WARNING: This procedure should NOT be performed
when a cycle is running or the Platen is moving.
To install a polishing fixture on the overarm mandrel follow these
steps:
1. Raise the overarm to the full vertical position, locking the
overarm in place (see unpacking & setup instructions, for raising
the overarm. NOTE: You must have the compressed air hose
connected to the back of the machine to raise and lower
overarm).
2. Ensure the overarm shaft and fixture bore are clean before
proceeding. Wipe with IPA, cloth, and cotton swabs if dirty.
3. With a “Fixture Retaining Screw” or “Spring Clamp” on the
fixture, attach the fixture to the overarm. The screw allows the
fixture to slide on the shaft without falling off.
4. Lower and lock the overarm into the full horizontal position by
pushing and holding the “Quick Release” button while holding the
fixture up against the anti-rotational keys. Release the button
as you slowly lower the fixture onto the Platen. This technique
should be used whenever moving the overarm with a fixture in
place to protect both the fixture and the Platen.
WARNING: The overarm should be handled with extreme
care. Never drop or abuse the overarm as the load cell
may be damaged. Misuse is not covered under the normal
machine warranty.
33
