f. #10-32 X 3/8 Button Head Screw
g. Cable Tie
h. Cable Tie Mount
2. Remove the four Cap screws from the
top of the Load-Cell housing of the
Polishing Machine using the 3/32”
Hex L-Wrench.
3. Remove the Thumb Screws from the top
of the Micro-G® Head that are connect-
ed to the Fixture Latching Rods. Remove
the Latching Rods from the Head. Keep
the Thumb Screw & Latching Rod
together as a matched set. The cross
pin on the Latching Rod should be
parallel to the arms on the head of the
Thumb
Screw
when
assembled.
4. Remove the four M3 X 8mm
Button Head Screws and Mounting
Plate from the Head with the
5/64” or 2mm Hex L-Wrench.
5. Install the Mounting Plate on the Polishing Machine Load-Cell
housing with the
four #5-40 X 3/4”
Cap Head Screws
using the 3/32”
Hex L-Wrench.
45
