Dodge 2015 Charger SRT 392, Operating Instructions Manual

Page: 78 / 686

This feature can be programmed through the
Uconnect® system. Refer to “Uconnect® Set-
tings” in “Understanding Your Instrument Panel”
for further information.
Rear Heated Seats
On some models, the two outboard seats are
equipped with heated seats. The heated seat
switches for these seats are located on the rear
of the center console. There are two heated
seat switches
that allow the rear passengers
to operate the seats independently.
You can choose from HI, LO or OFF heat
settings. The indicator lights in each switch
indicate the level of heat in use. Two indicator
lights will illuminate for HI, one for LO and none
for OFF.
•
Push the heated seat button once to
select HI-level heating.
•
Push the heated seat button a second
time to select LO-level heating.
•
Push the heated seat button a third time
to turn the heating elements OFF.
NOTE:
•
Once a heat setting is selected, heat will
be felt within two to five minutes.
•
The engine must be running for the
heated seats to operate.
When the HI-level setting is selected, the heater
will provide a boosted heat level during the first
four minutes of operation. Then, the heat output
will drop to the normal HI-level. If the HI-level
setting is selected, the system will automatically
switch to LO-level after approximately 60 min-
utes of continuous operation. At that time, the
number of illuminated LEDs changes from two
to one, indicating the change. The LO-level
setting will turn OFF automatically after approxi-
mately 45 minutes.
Front Ventilated Seats — If
Equipped
Located in the seat cushion and seat back are
small fans that draw the air from the passenger
compartment and move air through fine perfo-
rations in the seat cover to help keep the driver
and front passenger cooler in higher ambient
temperatures. The fans operate at two speeds,
HI and LO.
The front ventilated seats control buttons are
located within the Uconnect® system. You can
gain access to the control buttons through the
climate screen or the controls screen.
•
Press the ventilated seat button once to
choose HI.
•
Press the ventilated seat button a second
time to choose LO.
•
Press the ventilated seat button a third
time to turn the ventilated seat OFF.
NOTE:
The engine must be running for the venti-
lated seats to operate.
Head Restraints
Head restraints are designed to reduce the risk
of injury by restricting head movement in the
event of a rear impact. Head restraints should
be adjusted so that the top of the head restraint
is located above the top of your ear.
75