Dodge 2015 Charger SRT 392, Operating Instructions Manual

Page: 14 / 686

A WORD ABOUT YOUR KEYS
Your vehicle uses a keyless ignition system.
This system consists of a Key Fob with Remote
Keyless Entry (RKE) transmitter and a Keyless
Push Button Ignition.
Keyless Push Button Ignition
This feature allows the driver to operate the
ignition with the push of a button as long as the
Remote Keyless Entry (RKE) transmitter is in
the passenger compartment.
The Keyless Push Button Ignition has four
operating positions, three of which are labeled
and will illuminate when in position. The three
positions are: OFF, ACC, and ON/RUN. The
fourth position is START. During start, ON/RUN
will illuminate.
NOTE:
In case the ignition does not change with the
push of a button, the RKE transmitter (Key
Fob) may have a low or dead battery. In this
situation, a back up method can be used to
operate the ignition switch. Put the nose side
(side opposite of the emergency key) of the
Key Fob against the Engine START/STOP but-
ton and push to operate the ignition. SRT Key Fobs
NOTE:
SRT vehicles equipped with the 6.2L Super-
charged engine comes with three key fobs
(two red and one black) that allow for differ-
ent engine power levels. Please refer to the
ⴖ
Drive Modes
ⴖ
in the “Uconnect Settings”
section for further descriptions.
The Key Fob also contains the Remote Keyless
Entry (RKE) transmitter and an emergency key,
which stores in the rear of the Key Fob.
The emergency key allows for entry into the
vehicle should the battery in the vehicle or the
Key Fob go dead. The emergency key is also
for locking/unlocking the glove compartment.
You can keep the emergency key with you when
valet parking.
To remove the emergency key, slide the me-
chanical latch on the back of the Key Fob
sideways with your thumb and then pull the key
out with your other hand.
Keyless Push Button Ignition
1 — OFF
2 — ACC (ACCESSORY)
3 — ON/RUN
11