Dodge 2015 Charger SRT 392, Operating Instructions Manual

Page: 152 / 686

•
The feature will “ready” when the vehicle is at
0 mph (0 km/h). The word “READY” will flash
when conditions are met for the event to
begin.
•
Dashes will display if the vehicle fails to
reach 1/4 mile (400 meters) in less then 25
seconds.
•
To clear the vehicle’s best 1/4 mile 400
meters) run, push and hold the OK button for
two seconds.
Braking Distance
When selected, this screen displays the vehi-
cle’s braking distance, and the speed at which
the brake pedal was pushed.
•
This feature will only function when applying
the brakes at speeds above 30 mph
(48 km/h).
•
Engaging the parking brake will disable this
feature.
•
The word “READY” will display when condi-
tions are met for the event to begin.
•
The distance and speed measurements dis-
play while the event is taking place.
•
The distance measurement will be aborted if
the brake pedal is released before the ve-
hicle comes to a complete stop.
•
Pushing and holding the OK button will clear
the current and last run values.
Current G-Force
When selected, this screen displays the current
G-Force (lateral and longitudinal) that displays
the directions of the forces.
Peak G-Force
When selected, this screen displays all four
G-Force values (two lateral and two longitudi-
nal).
•
When a force greater than zero is measured,
the display will update the value as it climbs.
As the G-Force falls, the peak forces will
continue to display.
•
Push and hold the OK button to clear the
peak force values.
Lap Timer
When selected, the Lap Timer page will show
the timer always at 0:00.00 with the previous
Best and Last time data (unless the driver has
cleared it via hold to Reset).
•
Pushing OK will start “current” timer from
0:00.0.
•
When OK is pushed, the times are updated
accordingly.
•
As soon as the driver exits the Lap Timer
pages, the “current” timer will stop and the
time will be reset to 0:00.00.
•
If the driver stays on the Lap Timer pages,
the “current” timer will reset to 0:00.0 when
ignition is placed in the off position, or ignition
placed in the ON position (or will roll over at
59:59.99 if ever possible).
•
Each time the driver pushes OK for a Lap
that current time populates, the Last time and
also populates the 1st (top) space on the
Timer History page the current time resets to
0:00.0 at every push of the OK button.
•
The timer will stop when the driver navigates
away from this page.
149