Dodge 2015 Charger SRT 392, Operating Instructions Manual

Page: 92 / 686

Heated Windshield Washer Nozzles
This feature utilizes a heating element to thaw
out any ice buildup that could occur at the
outlets or within the windshield washer nozzles.
To activate, push the rear window defroster
button. When the rear window defroster times
out, the heating element will also shut off. If
required, to reactivate the heated nozzles push
the rear window defroster button as needed.
NOTE:
The heated washer nozzles only apply heat
to the nozzle outlets to prevent them from
freezing and allow the nozzles to dispense
windshield washer fluid. Always remove any
buildup of snow or ice in front of the washer
nozzles as this will prevent the windshield
washer fluid from reaching the windshield.
Mist Feature
Rotate the end of the lever downward to the
Mist position to activate a single wipe cycle to
clear off road mist or spray from a passing
vehicle. The wipers will continue to operate until
you release the multifunction lever.
NOTE:
The mist feature does not activate the
washer pump; therefore, no washer fluid will
be sprayed on the windshield. The wash
function must be used in order to spray the
windshield with washer fluid.
Headlights On With Wipers
(Available With Automatic
Headlights Only)
When this feature is active, the headlights will
turn on after the wipers are turned on if the
headlight switch is placed in the AUTO position
and programmable feature is set to ON. In
addition, the headlights will turn off when the
wipers are turned off if they were turned on by
this feature.
NOTE:
The Headlights On with Wipers feature can
be turned on or off using the Uconnect®
System. Refer to “Uconnect® Settings/
Customer Programmable Features” in “Un-
derstanding Your Instrument Panel” for fur-
ther information.
Rain Sensing Wipers — If Equipped
This feature senses moisture on the windshield
and automatically activates the wipers for the
driver. The feature is especially useful for road
splash or overspray from the windshield wash-
ers of the vehicle ahead. Rotate the end of the
multifunction lever to one of four settings to
activate this feature.
The sensitivity of the system can be adjusted
with the multifunction lever. Wiper delay posi-
tion 1 is the least sensitive, and wiper delay
position 4 is the most sensitive. Setting 3 should
be used for normal rain conditions. Settings 1
and 2 can be used if the driver desires less
wiper sensitivity. Setting 4 can be used if the
driver desires more sensitivity. Place the wiper
switch in the OFF position when not using the
system.
NOTE:
•
The Rain Sensing feature will not operate
when the wiper switch is in the low or
high-speed position.
•
The Rain Sensing feature may not func-
tion properly when ice, or dried salt water
is present on the windshield.
89