Dodge 2015 Charger SRT 392, Operating Instructions Manual, Page: 258 / 686

6. Remove the jack and lug wrench assembly
from under the spare tire. Turn the jack
screw to the left to loosen the lug wrench,
and remove the wrench from the jack as-
sembly.
WARNING!
A loose tire or jack thrown forward in a
collision or hard stop could endanger the
occupants of the vehicle. Always stow the
jack parts and the spare tire in the places
provided. Have the deflated (flat) tire re-
paired or replaced immediately.
Preparations For Jacking
1. Park the vehicle on a firm, level surface as
far from the edge of the roadway as pos-
sible. Avoid icy or slippery areas.
WARNING!
Do not attempt to change a tire on the side of
the vehicle close to moving traffic, pull far
enough off the road to avoid being hit when
operating the jack or changing the wheel.
2. Turn on the Hazard Warning flasher.
3. Set the parking brake.
4. Place the shift lever/gear selector into PARK.
5. Turn OFF the ignition.
6. Block both the front and rear of the wheel
diagonally opposite
of the jacking posi-
tion. For example, if
changing the right
front tire, block the
left rear wheel.
NOTE:
Passengers should not remain in the vehicle
when the vehicle is being jacked.
Jacking And Changing A Tire
WARNING!
Carefully follow these tire changing warnings
to help prevent personal injury or damage to
your vehicle:
•
Always park on a firm, level surface as far
from the edge of the roadway as possible
before raising the vehicle.
•
Turn on the Hazard Warning flasher.
•
Block the wheel diagonally opposite the
wheel to be raised.
•
Set the parking brake firmly and set an
automatic transmission in PARK; a manual
transmission in REVERSE.
•
Never start or run the engine with the
vehicle on a jack.
•
Do not let anyone sit in the vehicle when it
is on a jack.
(Continued)
255