Appendix/Index
177
●
Cannot perform data communication overseas.
Check the data roaming settings.
→
P168
■
Data management
●
Data saved in microSD card is not displayed.
Reattach the microSD card.
→
P29
●
Data transfer is not performed.
Do you use USB HUB? If you use USB HUB, operations
may not be performed correctly.
■
Bluetooth
●
The terminal cannot be connected to a Bluetooth device/
A Bluetooth communication device cannot be found
from the terminal.
Make Bluetooth device registering stand-by state and then
register the device on the terminal. If you delete already
registered device and register the device again as a new
device, delete the registrations on both the terminal and
Bluetooth device and then perform registration of the
devices.
●
Calls cannot be made from the terminal connected to an
external device such as car navigation or handsfree
device.
If calls are made several times when the other party does
not answer or is out of service, the call to this number
may be disabled. In this case, turn the terminal OFF and
ON.
■
Maps/GPS function
●
Cannot set AUTO-GPS service information.
• Is AUTO-GPS function disabled due to battery low? If
AUTO-GPS is disabled by Lower-power operation
settings, AUTO-GPS service information cannot be set.
In this case, set Lower-power operation settings to [Not
suspend] or charge the battery.
→
P82
• Is AUTO-GPS operation settings set to [OFF]?
→
P82
• Is GPS function set to [OFF]? When GPS function is
[OFF], AUTO-GPS function stops.
→
P82
■
Others
●
When performing fingerprint authentication or
registering fingerprints, "Swipe was too short" or
"Swipe was too slow", etc. appears without touching
the fingerprint sensor.
Possible cause is that the surface of the fingerprint sensor
is wet or condensed of moisture. Wipe water off with a
soft cloth before use.
●
Screen display turns off when using the fingerprint
sensor.
The terminal goes into sleep mode by pressing the
fingerprint sensor. Slide your finger over the fingerprint
sensor not pressing the sensor.
●
Fingerprint authentication is unavailable when
connecting terminal with a PC, etc.
When connecting the terminal using a USB cable to a
device which requires grounding such as a desktop PC,
make sure that the device is grounded in advance. If the
connected device is not grounded, fingerprint
authentication may be unavailable. In such a case,
disconnect the terminal from the device and retry
fingerprint authentication.
Summary of Contents for F-02E Arrows X
Page 1: ...F 02E INSTRUCTION MANUAL 13 2...
Page 204: ...Appendix Index 202 z 1Seg 140...
