15
Wireless room thermostat DK LOGIC 200
13.3 Example - programming the automatic operation mode
(cont.)
Note:
If no changes are made for three minutes in the PROG mode,
the controller will automatically go to the AUTO mode.
!
14. Momentary temp. change in automatic mode
This function allows temporary change of the heating temperature set in AUTO
mode. It can be made by pressing the “-/+” buttons; such a temperature will be
maintained until the activation of the next program.
10.
Without making any changes, press for a
few times until the main screen is shown.
AUTO
15. MANU mode - manual operation mode
The MANU mode allows changing the heating temperature without interfering
with the set program.
2.
Use the “-/+” button to set the required
temperature; a thermostat will keep it until the
next manual change or switching the controller
to the automatic mode.
1.
Press the button for a few Times till the
MANU symbol and temperature appears.
MANU
MANU
3.
After a while, the controller will automatically
switch to perform manual settings, and the
screen will show the current measured
temperature or hour (depending on setting the
Par1 - see point 19
“PAr1 - parameter visible
on the main screen”
).
MANU
16. TEST function
The TEST function allows controlling the proper
connection of the controller to the boiler or
programmer.
Press the button , and then . TEST will be
displayed on a screen, and the controller will
perform several cycles of turning the boiler on and
off - the function active in AUTO and MANU mode.
MANU
P
