GB
25
GLOBE - IP1839
Problem
Possible cause
Remedy
The automation does not open
and close.
No power.
(POWER ALARM LED off).
Check that the control panel is on.
Accessories in short circuit.
(POWER ALARM LED flashing).
Disconnect all the accessories from the terminals
0-1 (24 V= are required) and reconnect these one
at a time.
Line fuse burnt out.
(POWER ALARM LED off).
Replace the fuse F1.
The stop contact is open
Check terminal 9 of the control panel
The automation opens but does
not close
The safety contacts are open.
(SA LED on).
Check terminal 8 of the control panel.
The photocells (if fitted) are triggered.
(SA LED on).
Make sure the photocells are clean and working
properly.
Automatic closing does not work.
Check the setting of the TC trimmer
The automation fails to open.
The automation is closed and the photocells (if
fitted) are operative.
(SA LED on).
Make sure the photocells are clean and working
properly.
See jumper SO.
Remote control does not work.
Make sure the transmitters have been properly
stored on the built-in radio receiver. In case of
failure of the radio receiver built in the control
panel, the remote control codes can be accessed
by extracting the memory module.
Command devices faulty or connections
interrupted.
Check opening by means of jumper 1-5 of the
terminal board control panel.
The external safety devices (if
fitted) fail to operate.
Wrong connections between the photocells and
the control panel
Connect the N.C. safety contacts together in series
and remove any jumpers on the terminal board of
the control panel.
The automation opens/closes
for a short distance and then
stops.
Encoder faulty.
(POWER ALARM LED flashing).
Replace the encoder.
Motor leads reversed.
(POWER ALARM LED flashing).
Check the motor leads.
There are frictions.
Manually make sure the automation is moving
freely.
Encoder not connected.
Check the connection.
False encoder contacts.
Clean the contacts by engaging and disengaging
the encoder plug on the contacts.
R1 set too low.
Check R1 adjustment.
The radio remote control has a
low range and does not work
with the automation in motion.
Radio transmission is hampered by metal
frameworks and reinforced concrete walls.
Install the antenna outside. Replace the batteries
of the transmitters.
8. TROUBLESHOOTING
Summary of Contents for GLOBE IP1839
