Reference
129
Troubleshooting Tables
You set an event timer.
The event timer misses the
beginning or the end of a
program.
•
The program may have
started a little earlier than
scheduled, or it may have run
over its scheduled ending
time.
•
Use the Start Early & End Late options, except for
a Pay-Per-View event.
•
Use a manual event timer to start any event timer
at the times you set yourself, except for a Pay-
Per-View event.
Hearing A Program
What Is Happening
Possible Reason
What to Do
The receiver front panel power
light is on and there is a good
picture on the TV set, but you
do not hear any sound.
•
You may have muted the
sound, or set the volume so
low that you cannot hear it.
•
The audio connections may
not be properly connected.
•
You have selected Dolby
Digital Only when there is no
Dolby Digital soundtrack.
•
Check the volume level on the TV or audio
device. Turn off the mute or turn up the volume,
as required.
•
Check the audio connectors and cables from the
receiver to the TV or the sound system.
•
Check the TV speakers or the sound system.
•
In the Dolby Digital menu, select
Dolby Digital/
PCM
for the audio output. If your decoder/
amplifier will not accept Linear PCM digital input,
use the analog connections instead.
You hear a foreign language
with a program.
•
You may have set the receiver
to select an alternate audio
language. The program may
be in a foreign language.
•
Press the MENU button on your remote. From
the Main Menu, select
Preferences
, then
Alternate Audio
, and choose the language that
you prefer.
Caller ID
What Is Happening
Possible Reason
What to Do
Caller ID is not working.
•
You do not have Caller ID
service from your local phone
company.
•
Verify that Caller ID is a service provided by your
local phone company and you have subscribed to
it.
•
Your phone line is not
connected to the phone jack
on the back of the receiver.
•
Verify that you have connected the phone line to
the phone jack on the back of the receiver.
•
You do not have the Caller ID
option enabled.
•
Press the MENU button on your remote. From the
Main Menu, select
System Setup
, then
Installation
, and then
Caller ID
. Select the
Enable Caller ID
option.
Timers
What Is Happening
Possible Reason
What to Do
Summary of Contents for 722_TOC
