9
4.0 LYNK II CAN Hardware Termination and CAN Out PIN Configuration
4.1 LYNK II CAN Termination
NOTE
Disconnect power and all connections to LYNK II before attempting to configure
header jumpers.
Jumpers are used to configure termination for AEbus and LYNK Network, and the
CAN Out PIN assignments. Follow the
LYNK II User Manual (805-0033)
to learn
how to access and configure the header board with jumpers.
Detailed PIN configurations are included in the LYNK II User Manual but are
repeated here for convenience.
NOTE
LYNK II terminates the AEbus and LYNK Network by default. Do not remove the
termination jumper inside LYNK II unless instructed to do so by Discover Battery.
4.2 LYNK II CAN Out - RJ45 PIN Assignments for Sol-Ark Inverters
CAN signals (CAN H, CAN L, CAN GND) can be assigned to any PIN of the
RJ-45 connector by adjusting the jumpers on the header board.
NOTE
There are different ground pin (CAN GND) assignments for the Sol-Ark indoor
(Legacy) and outdoor inverter-chargers.
Summary of Contents for 950-0025
Page 1: ...1 805 0038 REV A 950 0025 SOL ARK USER MANUAL...
Page 28: ...28 NOTES...
