4 Configurations on Web Interface
DAG1000-1S/2S/4S User Manual
Copyright©2011-2017 Dinstar
35
Table 4-6 Explanation of FXS Parameters
Timeout for dialing
With the help of dialing timeout, you can limit the time between
two digits while users are typing the digits of a number through an
extension. If the timeout expires, the device will consider the
dialing has finished and will try to send message to SIP server.
Default value is 4 seconds.
Timeout
for
answer(Outgoing call)
This parameter determines how long the caller party will wait for
answer when making outgoing calls through a phone.
Timeout
for
answer(Incoming call)
This parameter determines how long the phone rings when there are
incoming calls
No RTP Detected
If this parameter is enabled, the situation will be detected when
there is no RTP packets received during the set time period.
Period without RTP
Packet
The time period when there is no RTP packets received.
Call Process Tone
The signal tone standard after a phone is picked up. Choose
national standards from the drop-down box. Default value is USA.
Auto Gain Control
Whether to enable automatic gain control
Send Polarity Reversal
If polarity reversal is enabled, call tolls will be calculated based on
the changes in voltage. If polarity reverse is disabled, you need to
set the time for offhook detection and call tolls will be calculated
starting from the set time.
Detect Hook flash
If ‘Detect Hook Flash’ is enabled, you need to set a minimum time
and a maximum time. If a phone’s hook flash is pressed for a time
period greater than the set minimum time but less than the
maximum time, the action is considered as a ‘hook flash’ operation.
If a phone’s hook flash is pressed for more the set maximum time,
the action is considered as ‘hang up the phone’.
CID Type
There are two CID types, namely DTMF and FSK.
Message Type
There are two call display types including SDMF and MDMF
Message Format
The call display format in analog phone. It can be “Display Name
and CID”, “CID only”, or “Display Name only”; default value is
“Display Name and CID”
Send CID before Ringing
If this parameter is enabled, the device send Caller ID to phone
before ringing, otherwise the caller ID will be displayed after
ringing.
Delay of sending CID
after Ringing
The time how long the caller ID will be delayed when the caller ID
is set to be displayed after ringing. Default value is 500ms.
CFNRy Timeout
Timeout for ‘call forwarding on no answer’ service
