Dinolift DINO 105T, Operating Instructions Manual, Page: 55 / 78

DINO 105T
55
Test loading instruction for regular inspection
1. Place the lift on an even surface with good carrying capacity. Push the outriggers to their
lowest position (the minimum support width)
2. Turn the boom to the side from top of the towbar and lower it on the ground.
3. Put a weighed load of 120 kg on the platform.
4. Lift the boom to as high as it goes and extend the telescope to its full length (maximum
lifting height).
5. Lower the boom to the horizontal plane (maximum outreach).
6. Turn the boom round over 360° and establish the standing stability
7. Retract the telescope and lower the boom.
8. Exend the telescope and remove the load from the platform.
If the above mentioned test loading and the subsequent inspection have been completed without any
remarks concerning the structure or stability of the lift, the lift may be used in accordance with the
permissible outreach / platform load chart presented on page 7 of this manual.
The max. allowed platform load is 120 kg.
- The lift shall be subjected in connection with the first i.e. start-up inspection to a test loading
with an overload of 25% and after that the supporting structures shall be thoroughly inspected.
- In conjunction with every annual inspections the lift shall be subjected to a test run with the
maximum permissible load and after that the supporting structures shall be thoroughly
inspected.
- The first inspection shall be recorded in the start-up inspection protocol. the test runs shall be
recorded in the protocols for the annual and regular inspection.