© 2022 Digitrax, Inc.
www.digitrax.com
12
12
3.14 LOCO RESET Button
The LOCO RESET button allows you to clear all decoder info and consists from your
. Pressing this button preforms the same function as closing OPSW 36. This
button is useful in clearing all locos from the system after a large operating session or if
you are getting a slot full error.
3.15 Easy Routes (EZ RTS) button
The EZ RTS button give your simple access to setting up routes in your . For
information on setting up routes refer to the Routes in
section 5.2
.
3.16 Audible Sounds
The uses several beeps and clicks that can be used as diagnostic tools that
help you debug a number of conditions. Some Audible sounds mean different things
depending on the ’s current mode.
Sound
Meaning
Continuous short
beeps
In Voltage Trim Mode, selection is in range.
1 Short Beep
Diagnostic Beep when OPSW41 = c, LocoNet commands incoming. In EZ
routes mode indicates a switch has been saved. During operation,
has recovered from a fault
2 Short Beeps
Initial Power on or had purged a loco address
3 Short Beeps
Entered quick routes mode
4 short Beeps
Booster short circuit shutdown.
5 Short Beeps
Route Error, looping route
8 Short Beeps
Route Error, Maximum switch commands issued.
1 Long Beeps
In EZ routes, initial Route ID saved
2 Long Beeps
In EZ routes, route saved and exit EZ Routes
3 Long Beeps
When pressing the Loco Reset Button, all loco addresses purged from the
system.
4 Long Beeps
Input Voltage is out of the range 13.8V to 24V DC
10 Long Beeps
has detected another Command Station on LocoNet and has
turned off
track power.
