DIGITIZE DGM-32/64, Installation And Maintenance Manual

Page: 52 / 59

DGM INSTALLATION AND MAINTENANCE MANUAL
42 700135-0000 Rev. O
5.3.1.3 LOW BATT
The Low Batt message will be displayed if the battery voltage falls to 10.5 VDC. When the
voltage goes above the value, the message will disappear.
5.3.1.4 BATTERY FAULT
The Battery Fault message will be displayed if the battery is not connected.
5.3.1.5 GROUND DETECT
If a ground should be detected on any of the zone inputs, the GROUND DETECT
message will display. A ground is required to remain constant for a period of two minutes
before it is reported.
NOTE: The ALARM and TROUBLE LED’s may be lit at the same time if an alarm and a
trouble condition exist on two or more zones.
5.3.2 LED INDICATORS
5.3.2.1 ALARM LED
The ALARM LED will be illuminated any time one or more zones are in alarm condition.
5.3.2.2 TROUBLE LED
The TROUBLE LED will be illuminated any time a zone is in trouble. It will also be lit any
time the DGM is in reset mode.
5.3.2.3 AC POWER LED
The AC POWER LED will be lit any time AC power is available to the DGM.
5.3.2.4 DC POWER LED
The DC POWER LED will be lit any time DC power is available
to the IC’s.
5.3.2.5 TRANSMITTER LED
The TRANSMITTER LED will be lit only when the DGM is transmitting data to the
SYSTEM 3505 PRISM LX. Upon initialization the TRANSMITTER LED flashes to
indicate that the SYSTEM 3505 PRISM LX has recognized the DGM panel, and that the
DGM is responding.
5.3.2.6 RESET LED
The RESET LED will be lit when an internal malfunction occurs on the DGM. If this LED
illuminates, you must push the RESET button. Upon initialization, the RESET LED
flashes every few seconds to indicate successful operation of the panel.
5.3.3 BEEPER
The following conditions will cause the beeper to sound:
- A change in zone status (when function enabled).
- A Tilt or Tamper occurs, including an open door.
- A system fault.