DigiTech GNX3, User Manual

Page: 15 / 84

S/PDIF Digital Output
Connect the GNX3’s S/PDIF output to the S/PDIF input on your digital audio compatible mixer or
computer sound card. You must have S/PDIF inputs on the receiving device in order to use this output.
Be sure to use a 75 ohm or RCA video cable to connect from the Digital Output to the input of the
other device. You can use the analog and digital outputs of the GNX3 simultaneously
NOTE: Do not connect the S/PDIF output to analog auxiliary, CD, phono, or tape inputs on
consumer electronic devices. It is not compatible with these inputs.
Applying Power
Once the audio connections are made, turn the GNX3’s Output Level, on the rear panel, all the way
down (counterclockwise). Connect the PSS3 to the power jack, on the back of the GNX3, and the other
end to an AC outlet. Turn the power switch On. Turn the power to your amplifier(s) on. Set the amp(s)
to a clean tone and set the tone controls to a flat EQ response (on most amps, this would be 0 or 5 on
the tone controls). Turn the Output Level of the GNX3 up to increase the volume.
About the GNX3
The Presets
A preset is a named and numbered location of a programmed sound that resides in the GNX3. Presets
can be recalled with the
FOOTSWITCHES or the DATA WHEEL . The GNX3 comes with 65
Factory and 65 User presets. The Factory Presets do not let you store changes to them. The User
presets let you store changes. From the factory, the 65 User presets are exact duplicates of the 65
Factory presets. This lets you create your own presets without worrying about losing any of the original
PAN / LEVEL SETUP REMAIN
SONG
9
Introduction