DigiTech GNX3, User Manual

Page: 30 / 84

A Chorus adds a short delay to your signal.The delayed signal is modulated in and out of tune and
then mixed back with the original signal to create a thicker sound.
Parameter 1 - The Parameter 2 knob adjusts the rate (
Speed
) of the modulation. Ranges from 1 to
99.
* These Parameters are only available using the GenEdit™ computer editor software.
Parameter 2 - The Parameter 3 knob adjusts the intensity (
Depth
) of the modulation. Ranges from
1 to 99.
Parameter 3 - The Parameter 4 knob adjusts the PreDelay (
PREDeLaY
) or length of time before the
Chorus effect is applied to the input signal. Ranges from 1 to 20.
* Parameter 4 - Selects the waveform used by the Chorus.Waveforms include: Triangle , Sine, and
Square.
* Parameter 5 - Adjusts the left to right balance of the wet signal. Ranges from L 99 to R 99.
Mod Level - The Parameter 5 knob controls the level (
mod levl
) of the Chorus. Ranges from 0 to
99.
Flanger
A Flanger uses the same principle as a Chorus but has a shorter delay time and adds regeneration (or
repeats) to the modulating delay. This results in an exaggerated up and down sweeping motion to the
effect.
Parameter 1 - The Parameter 2 knob adjusts the rate (
Speed
) of the modulation. Ranges from 1 to
99.
Parameter 2 - The Parameter 3 knob adjusts the intensity (
Depth
) of the Modulation. Ranges from
1 to 99.
Parameter 3 - The Parameter 4 knob adjusts the amount of feedback (
Regen
) added to the Flanger
delay. Ranges from 0 to 99.
* Parameter 4 - Selects the waveform used by the Flanger.Waveforms include: Triangle , Sine, and
Square.
* These Parameters are only available using the G
EN
E
DIT
™ computer editor software.
* Parameter 5 - Adjusts the left to right balance of the wet signal. Ranges from L 99 to R 99.
Mod Mix - The Parameter 5 knob controls the mix (
mod mix
) of wet and dry signal. Ranges from 0
(all dry) to 99 (all wet).
Phaser
A Phaser splits the incoming signal, takes the split signal in and out of phase and mixes it back in with
the original signal. As the phasing changes, different frequencies are canceled resulting in a warm sort
of twisting sound.
Parameter 1 - The Parameter 2 knob adjusts the rate (
Speed
) of the modulating phase. Ranges
from 1 to 99.
Parameter 2 - The Parameter 3 knob adjusts the intensity (
Depth
) of the modulation. Ranges from
1 to 99.
Parameter 3 - The Parameter 4 knob adjusts the amount of effected signal returned to the input of
the Phaser (
Regen
). Ranges from 0 to 99.
* Parameter 4 - Selects the waveform used by the Phaser.Waveforms include: Triangle , Sine, and
Square.
* Parameter 5 - Adjusts the left to right balance of the wet signal. Ranges from L 99 to R 99.
24
Effects and Parameters