page 11
Digital Projection HIGHlite Cine 330 3D Series
Installation and Quick-Start Guide
OPERATING THE PROJECTOR
Rev E August 2014
Adjusting the lens
To access lens controls, do either of the following:
•
Press the
LENS
button on the remote.
•
Access the
Control
menu and navigate to
Lens Control
.
Use the arrow buttons to adjust
Zoom
,
Focus
and
Shift
.
Adjusting the image
Projector mode (orientation) and OSD settings
These can be set from the
System
menu.
Aspect ratio
To set up an aspect ratio for your image, do either of the following:
•
Press the
ASPECT RATIO
button on the remote control to cycle through the available settings.
•
Access the
Main
menu and then select
Aspect Ratio
.
Picture
To change brightness and contrast, do either of the following:
•
Press
BRIGHTNESS
or
CONTRAST
on the remote control, then use the arrow buttons to move the sliders.
•
Access the
Image
menu and adjust the
Brightness
and
Contrast
settings.
3D
In the
Main
menu, use the
3D Control
sub-menu.
Switching the projector off
1. Press
POWER
on the control panel or the remote control, then press the button again to confirm.
The lamp will switch off, the STANDBY indicator on the control panel will start flashing and the projector will be in STANDBY mode while
cooling off.
2. Wait until the power indicator has stopped flashing and the fans have stopped working, then disconnect the power cable.
Notes
Always allow the lamp to cool for
5 minutes before:
- disconnecting the power
- moving the projector
- changing the lamp
