Part 1:
Basic Operations
The following chapters describe how to send a print job to the DEClaser
1152 printer from different platforms using the factory default settings of
the printer. The following DEClaser 1152 factory default settings satisfy the
requirements for most single-host configurations:
•
Three enabled communications channels:
1.
Parallel (Centronics)
2.
Serial (Either EIA-232 or DEC423, not both)
3.
LocalTalk
•
All communications channels interpret the incoming data as PostScript.
•
The serial communications settings are:
9600 Baud
8 Data Bits
1 Stop Bit
No Parity
XON/XOFF flow control
To change the default settings of the printer, see the DEClaser 1152 Printer
Installation/Operator’s Guide, which lists other settings that may also be
selected. See Chapter 4 to use this printer in a multihost configuration.
