UTM-00330
|
Rev 5
Page
58
of
91
DetNet South Africa Copyright © 2019
This function enables the user to view battery charge information, current consumption, State-of-health of the
battery, temperature information, hardware and software serial numbers, GPS detail and User ID.
1.
Main Menu
Press
Soft Key to view
System Info
2.
System Info - Battery
100%: Battery charge information (The charging
source will be displayed as either USB when a USB
source is used or AUX when a wireless charger is
used. Should the charger not be able to supply enough
power to charge the Tagger, ‘Weak Charger’ will be
indicated as the charging status, instead of ‘Charging
(USB/AUX)’.
Current Consumption: By convention a negative value
indicates that current is being drawn from the battery.
Cell Status: (Good) indicates the state of health of the battery. Should the status indicate ‘Low’ the unit
should be serviced to have the battery replaced.
3.
Temperature and the Relative Humidity as measured inside the Tagger are displayed as follows:
Temp: The Temperature is displayed in degrees Celsius and Fahrenheit.
Humidity: The Relative Humidity is displayed as a percentage.
4.
System Info – Hardware Serial Number and SW Release Number
Press to select page right.
Hardware Serial Number will be displayed.
Software Release Number will be displayed
The Tagger will switch OFF automatically when the battery capacity drops below 3%
(The Tagger will display a warning at 9% and switch OFF at 3%).
Hardware Serial number is required when Challenge Response tickets are required
from the DetNet Portal.
SW Release: 34374B
