2
2.1.1. CD-RW
(Option)
The VCD series system can select the CD-RW as an Option. Use the CD-RW to backup the recorded image.
Refer to “Image Backup” for a detailed explanation.
2.1.2. Network
LED
LED is blue when the system is connected to any network client (RemoteAgent). Light is automatically out
when all clients are disconnected.
2.1.3. Alarm
LED
LED is lit if the system’s connected Alarm activates.
2.1.4. HDD
LED
LED is blue when the camera image is being stored into or retrieved from the HDD. So, even though the system
is continuously recording, the HDD LED is only lit when actual data is recorded in the HDD. Usually, the LED will
be flickering, and this is normal.
2.1.5. Power
LED
LED to show the power input and status of the system. The LED is red when the system is in stand-by
position, but is green when the system is working and power is being supplied.
2.1.6. USB
Port
Used to backup recorded images on the VCD series by using a USB storage device. A system software
upgrade is possible with a USB storage device.
Note
Refer to “Image Backup” for detailed explanation of USB storage devices supported by EM-3000 series.
2.1.7. Remote Controller Receiver
VCD can be operated conveniently, using the remote controller. Receives input signal from the remote
controller
2.1.8. Power
Button
Connect the power cable of the product before pressing this button to turn the power on and off.
2.1.9. Select
Channel
These buttons are used to change the channel images. The Left/Right button is used to change the channel
on 1- screen mode or PIP mode, and Up/Down button is used to change PIP channel from PIP mode. These
buttons are also used to move the cursor in the “Setting” mode, up, down, left, or right, and also to increase
or decrease the setting value.
2.1.10. ENTER Button
The [Enter] button is used to go to the next stage, select value or settings.
2.1.11. RETURN Button
Use to cancel the password just typed at the setting menu or return to previous menu.
2.1.12. SETUP
Set the environment of the VCD system according to the user requirement. Refer to “Setting” for detailed
explanation.
2.1.13. Screen Mode Selection
Screen mode can be selected from the monitor screen. Whenever the buttons is pressed, it will change in
sequence in 1, 4, 8 and PIP screen.
Summary of Contents for VCD304161
Page 4: ......
Page 8: ......
Page 46: ...37 Enter a new password After entering the password re enter the same password again ...
