29
Place the pin extender (C) on the connector pins of the
rear unit (B).
NOTE:
Do not touch the rear unit connector pins (male
connector) against any metal or other conductive
surfaces. This may short the pins and cause damage
to the lock.
Step 1
Place the mounting screw posts of the front unit (A)
through the lock recessed mounting holes on the
front of the door.
Step 2
Place the rear unit (B) against the rear face of the door,
aligning its mounting holes with the mounting screw
posts from the front unit.
NOTE:
An audible triple beep and three flashes of the
LED indicates that the lock was connected properly. If
you do not hear these beeps, separate the units, press
the “C” button on the keypad and reconnect the front
and rear units on the door.
Step 3
Slide the front unit (A) and rear unit (B) together
making sure that the pins of the rear unit connector align
with the female connector of the front unit (A).
Step 4
