17
Lock Handing
Door Prep Requirements
1) Disconnect the front unit from the rear unit.
2) Hold down
=
Button for one full second.
3) Reconnect the units with the desired handing or connect them as part of the installation.
To change handing:
Left Handed
Right Handed
FIG. B
FIG. A
Strike Plate
NOTE:
See Door Preparation Instructions for more information on pages 14-16.
Before installing, your door must be prepped with a Strike Plate (Figure A)
and lock mounting holes (Figure B).
NOTE:
If the handing has been previously registered by connecting and operating the lock prior to installation on the door,
the lock may not function if the initial handing is different than the installation on the door. Both bolt and latch locks
can be right or left handed. Bolt shown above for demonstration purposes.
