NOTE:
An audible triple beep and three flashes of the
LED indicates that the lock was connected properly. If
you do not hear these beeps, separate the units, press
the “C” button on the keypad and reconnect the front
and rear units on the door.
WARNING:
Do not overtighten screws.
20
While holding the front unit (A) against the front of the
door, bring the rear unit (C) against the rear face of
the door, aligning the screws in the rear unit with the
mounting nut posts from the front unit.
Step 5
Slide the front unit (A) and rear unit (C) together
making sure that the pins of the rear unit connector
align with the pins of the front unit connector and hand
tighten the mounting screws.
Step 6
Follow the Programming section of this
manual on pages 34-39.
Step 8
Step 7
NOTE:
If during operation of the lock, the lock
emits 10 rapid beeps and 10 flashes of the LED
light, it is an indicator that the bolt/latch of the lock
is binding with the door strike plate and/or frame. If
this occurs, the door and/or strike plate may need to
be aligned or adjusted. It may also be an indicator
that the mounting screws are over tightened or due
to overtightening in Step 6.
Test the operation several times (as indicated
below) while the door is open. Close the door and
test the unit again. Make sure there is no binding
between the bolt/latch and the door strike plate and/
or frame. Adjust alignment if necessary.
To lock and unlock enter:
=
then
`
