30
Follow the Programming section of this
manual on pages 34-39.
Step 7
Place the locking nuts (D) over the mounting screw
posts and hand tighten to secure the lock to the door.
Step 5
WARNING:
Do not overtighten screws.
Step 6
NOTE:
If during operation of the lock, the lock
emits 10 rapid beeps and 10 flashes of the LED
light, it is an indicator that the bolt/latch of the lock
is binding with the door strike plate and/or frame. If
this occurs, the door and/or strike plate may need to
be aligned or adjusted. It may also be an indicator
that the locking nuts are over tightened on the screw
posts or due to overtightening in Step 5.
Test the operation several times (as indicated
below) while the door is open. Close the door and
test the unit again. Make sure there is no binding
between the bolt/latch and the door strike plate and/
or frame. Adjust alignment if necessary.
To lock and unlock enter:
=
then
`
