Command descriptions
TransPort LR User Guide
187
tx-multicast-packets
The number of multicast packets transmitted on the Ethernet interface.
rx-crc-errors
The number of received packets that do not contain the proper cyclic redundancy check (CRC), or
checksum value.
tx-crc-errors
The number of transmitted packets that do not contain the proper cyclic redundancy check (CRC), or
checksum value.
rx-drop-packets
The number of received packets that have been dropped on the Ethernet interface.
tx-drop-packets
The number of transmitted packets that have been dropped on the Ethernet interface.
rx-pause-packets
The number of pause packets received on the Ethernet interface. An overwhelmed network node can
send a packet, which halts the transmission of the sender for a specified period of time.
tx-pause-packets
The number of pause packets transmitted on the Ethernet interface.
rx-filtering-packets
The number of received packets that were blocked or dropped through packet filtering.
tx-collisionss
The number of collision events detected in transmitted data. Collisions occur when two devices
attempt to place a packet on the network at the same time. Collisions are detected when the signal
on the cable is equal to or exceeds the signal produced by two or more transceivers that are
transmitting simultaneously.
rx-alignment-error
The number of received packets that do not end on an 8-bit boundary, known as an alignment error.
rx-undersize-error
The number of received packets that do not end on an 8-bit boundary, known as an alignment error.
rx-fragment-error
The number of received packets that contain fewer than the required minimum of 64 bytes, and have
a bad CRC. Fragments are generally caused by collisions.
rx-oversize-error
The number of received packets that are larger than the maximum 1518 bytes and have a good CRC.
