Configure the device using the ConnectPort LTS web interface
Configuration through the web interface
Digi ConnectPort LTS User Guide
69
o
UDP Port
: The port number to send data to. If you are sending data to another Digi
device server use the raw UDP port number for its serial port. This is usually 2101 for
port 1. The format for this port number is as follows:
21<serial port number>
Replace <serial port number> is the Digi serial port number. For example, 2101 applies
to serial port 1, 2110 applies to serial port 10, and 2116 applies to serial port 16.
l
Send data under any of the following conditions
:
o
Send when data is present on the serial line
: Send the data to the network
destinations when a string of characters is detected in the serial data. To enter non-
printable characters, use these key sequences:
Character
Key
Sequence
hexadecimal
values
\xhh
tab
\t
line feed
\n
backslash
\\
o
Send after the following number of idle milliseconds
: Send the data after the
specified number of milliseconds have passed with no data received on the serial port.
o
Send after the following number of bytes
: Send the data after the specified number
of bytes have been received on the serial ports.
Network Services
Enable the access methods that will be used to connect to your serial device. This page displays the
currently configured TCP or UDP port.
n
Allow multiple connections
: Enable to allow multiple connections to the TCP server.
n
Enable Raw TCP access using TCP Port
: Enable raw TCP access method to access to the
specified port. The default is 2101 for port 1. The format for this port number is as follows:
21<serial port number>
Replace <serial port number> is the Digi serial port number. For example, 2101 applies to serial
port 1, 2110 applies to serial port 10, and 2116 applies to serial port 16.
