Dick SM-200 TE, Operating Instructions Manual, Page: 44 / 76

SM-200 TE Grinding and Honing Machine 44
Setting up the Machine
8
7 Place the hexagon socket of the double grinding lever on the
shaft of the universal mounting head. Align the hexagon
socket of the double grinding lever with the hexagon head of
the shaft.
8 Mount the clamping lever [1] onto the universal mounting
head again. Make sure that both hexagon sockets are
threaded.
9 Loosen the locking pin of the double grinding lever.
10 Rotate the grinding plate until the bolt engages.
11 Fasten the grinding plate and double grinding lever to the uni-
versal mounting head with the clamping lever
[1] .
Fasten the workpiece in the grinding plate after these initial steps.
1 Move the grinding arm to the middle height.
2 Place the double grinding lever in the fork of the grinding lever
support.
3 Lay the knife in the grinding plate and fasten with the rotary
lever of the grinding plate.
Checking the settings
Check the settings after this work. The contact point of the knife
edge on the grinding wheel should be positioned between 1 o'clock
and 2 o'clock.
WARNING
Machine knives have a sharp cutting edge. They could cause
serious injuries.
• Always wear cut-resistant gloves when working with machine
knives.
• Work with due care and attention.