SM-200 TE Grinding and Honing Machine
30
Putting the Machine into Operation
7
5
Place the cover with the pump back on the water tank.
6
Close the door
Perform steps 2, 3, 4 and 5 for the SM-200 TE grinding and honing
machine without a stand.
7.6
Electrical connection
• Connect the SM-200 TE grinding and honing machine only to
sockets with a clockwise rotating field and protective earth-
ing.
• Connect the machine only when it is switched off.
1
Before connecting the SM-200 TE grinding and honing
machine to the mains supply, check that the switches for the
abrasives and for the cooling water pump are set to zero.
2
Connect the power.
7.7
Performing test runs
Perform a test run for the abrasives and for the cooling water unit.
Test run for the abrasives
Check the direction of rotation of the abrasives. The grinding belt
and polishing wheel must rotate in the direction of the arrows for
the direction of rotation on the front of the machine. A second test
run checks the cooling water supply.
1
Press the
I
(ON) button on the main On/Off switch.
2
Set the switch for the abrasives to position
I
(ON).
The grinding and honing machine starts up.
3
Check the direction of rotation of the grinding belt and polish-
ing wheel.
4
Set the switch for the abrasives to position
0
(OFF).
NOTE
Damage to the SM-200 TE grinding and honing machine due
to mismatching connection data.
• Compare the electrical data of the grinding and honing
machine (see "Technical data" on page 19) with the connec-
tion data on site before starting up the machine.
Summary of Contents for SM-200 TE
Page 76: ......