Dick SM-200 TE, Operating Instructions Manual, Page: 28 / 76

SM-200 TE Grinding and Honing Machine 28
Putting the Machine into Operation
7
7.2 Mounting the grinding arm
The grinding arm is supplied with the SM-200 TE grinding and hon-
ing machine. It is mounted on the scale head with the rounded
bearing side. The same steps are used for mounting the radial or
linear grinding arm.
1 Loosen the hexagon socket screw [2] on the grinding arm on
the bearing side and remove it together with the bearing plate
[3] .
2 Insert the bearing side of the grinding arm through the mount-
ing of the scale head until the edge of the other side is visible.
3 First place the bearing plate on the bearing side of the grind-
ing arm, then tighten the hexagon socket screw
[2] . The grind-
ing arm remains movable in the bearing.
4 Tighten the clamping screw [1] on the scale head. Tighten the
screw so that there is no play on the grinding arm, but the
grinding arm can move freely.
Disassemble the grinding arm before the grinding and honing
machine is ever transported in order to avoid damage. To do this,
perform the assembly steps in the reverse order.
Figure 7.1 – Mounting the grinding arm
[1] Scale head clamping screw
[2] Grinding arm screw
[3] Bearing plate
3
2
1