Diamond Atomix DH Series, User Manual

Page: 18 / 43

17
3.3.3 THREE-PHASE 2 SPEEDS AUTOMATIC (FIG.7):
TS12D-44D, TS12AD-44AD models allow the automatic control of working time in 1
st
and 2
nd
speed
using the timers relating to 1
st
and 2
nd
speed. It is possible to exclude the functioning of the timer in 1
st
and 2
nd
speed.
Operation without the timer
START : push the A1 button to start the bowl and the spiral on 1
st
speed; to switch to the 2
st
speed,
push the A2 button
STOP: push the B button to stop the bowl and the spiral.
If the mobile protection I Fig.8-9 is raised, the machine stops; to resume the working cycle, press
again the start button A1 (
1
st
speed )or A2 ( 2
st
speed) .).
Operation in Automatic mode:
This operating mode is obtained by setting the processing times in 1st and 2nd speed through the
selection buttons S1 for the first speed timer and S2 for the 2nd speed timer. Once set the times,
press the A1 button to start the working cycle.
The switch to the 2nd speed starts automatically when the time set in 1st speed is completed and the
cycle stops when the time set in 2nd speed is completed.
During the working cycle, the indicator light R flashes green; if the bowl protection is raised the color
turns red and stops flashing.
The L1 light is on and L2 is off in 1st speed; vice versa for 2nd speed.
Note: In a machine fed electrically by three-phase, if the rotation of the bowl is opposite the way shown by the arrow it is
necessary to follow these indications for the functioning and every time you change the electric plug:
· Stop the machine.
· Take the plug out.
· Reverse on the plug the position of two phases (example: L1 with L2 and vice versa).
· Restart the machine and verify if the bowl is rotating the right way.
Start the machine without using it, let it on for about one minute and verify that it is functioning perfectly.