Diamond Atomix DH Series, User Manual

Page: 17 / 43

16
· Restart the machine and verify if the bowl is rotating the right way.
Start the machine without using it, let it on for about one minute and verify that it is functioning perfectly.
3.3.2 TS12-44, TS12A-44A MODELS
Single-phase and three-phase machines (Fig.6):
Single-phase models TS12M-44M, TS12AM-44AM and three-phase models TS12T-44T, TS12AT-44AT
allow the setting of time working with a timer. It is possible to exclude the functioning of the timer .
Operation without the timer
START:
push the green button A to start the bowl and the spiral.
STOP : push the red button to stop the bowl and the spiral.
During operation, the R warning light indicated (Fig. 6) is green, while if the mobile protection I Fig.8-9
is raised, the warning light turns red, indicating the intervention of the safety system of the machine.
To resume processing, lower the mobile protection, letter I fig.8-9, and press start again (button A).
Operation with timer:
The timer manages the duration of the working cycle.
The working time is set using the ± buttons indicated by the letter S in fig.6. The selected time is
expressed in minutes and displayed on the display, indicated in fig.6 by the letter T.
After setting the time, press the start button A indicated in fig.6 and the led position R starts to flash.
During processing the time indicated by the display decreases. The machine stops automatically when
the set time is reset. An instant after the reset, the timer re-shows the duration set in the job just
completed.
P
I
Fig. 9