Diamond Products CC7574DKV, Operator'S Manual

Page: 56 / 72

CC7574DKV OPERATOR’S MANUAL
Replacing the Rear Wheels
Replace the rear wheels when they are
damaged and/or affecting saw performance.
Rear Wheel
1. Move the saw to level ground. Use a jack to
lift the rear wheels off the ground.
2. Pry the hubcap off the wheel using a
screwdriver or pry bar.
3. Remove all four lug nuts from the wheel.
4. Remove the wheel and place a new wheel
onto the wheel hub.
5. Replace the lug nuts and tighten to secure.
6. Replace the hubcap and secure in place
using a rubber mallet.
7. Replace the second rear wheel as directed.
Slowly lower the jack and remove the jack
stand when the wheels are firmly touching
the ground.
Maximum Cutting Depth
WARNING
• Raise the saw to a proper height for
access when working underneath the
saw. Use chocks to block the wheels,
and fit blocks or jacks under the frame
edges at the front and back of the frame.
Always adjust the maximum cutting depth
when changing the blade size, sheave size,
flange size, and belt size to avoid damaging
saw components. Refer to the CC7574DKV
Parts List for additional information.
1. Raise the saw to gain access to the
maximum cutting depth bolts underneath
the frame base.
2. Loosen the nut on both bolts.
3. Turn the bolts counterclockwise to
decrease the maximum cutting depth, or
turn the bolts clockwise to increase the
maximum cutting depth.
Note: Both bolts must be the same length
when finished.
Maximum Depth Bolts
4. Bottom out the nut on each bolt with the
frame base to secure the bolts.
5. Remove all tools from the area and lower
the saw completely. The blade flanges
must be at least 1/4” from the ground to
prevent component damage.
Note: Make sure both skid plates on the front
of the saw are in the correct set of holes to
lower the saw completely (refer to
CC7574DKV Parts List).
6. Readjust the depth bolts as necessary.
Handlebar Cylinder Rod
The handlebar cylinder rod must be serviced
by Diamond Products if the handlebars can be
moved up or down in excess amounts when
locked in place (movement may feel sluggish).
Send the entire assembly to Diamond
Products to be recharged or pressurized.
56