Diamond Products CC7574DKV, Operator'S Manual

Page: 50 / 72

CC7574DKV OPERATOR’S MANUAL
4. Remove oil drain hose from behind the
hydraulic lift pump.
Oil Drain Hose
5. Level saw frame and place drain pan
beneath drain hose.
6. Remove the engine oil fill cap.
Engine Oil Fill Cap
7. Remove red plastic drain plug and open
drain valve on side of oil pan located
behind the hydraulic lift pump.
Oil Drain Valve
8. Drain oil completely and dispose of
according to city, state, and federal
regulations.
9. Remove the oil filter located on the left side
of the engine using a filter wrench.
Engine Oil Filter
10. Dispose of the oil and filter in accordance
with city, state, and federal regulations.
11. Shut oil drain valve and replace red plastic
drain plug.
12. Install a new filter on the engine. Lubricate
the rubber gasket on the filter with a film of
oil prior to installing it.
13. Tighten the filter only hand tight.
14. Place a funnel with a flexible hose end into
the oil fill tube on the engine.
15. Add oil in accordance with the
manufacturer’s specifications and
capacities.
16. Replace the engine oil fill cap.
17. Reinstall the breaker panel curtain.
18. Close and latch the left side door.
500 Hour Service
Replacing the Hydraulic Oil Filter
Replace the hydraulic oil filter after the first 50
hours of operation, and then every 250 hours.
1. Lower the saw completely.
2. Place a drain pan under the filter.
Hydraulic Oil Filter
50